Registration Body Integrated Unit (Function Setting)

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

For the body integrated unit, function selection is available to control the entire vehicle systems. It is possible to control the original functions of vehicle when registrations of body integrated unit and function setting are corresponded to vehicle equipment.

If registrations and function setting are different from vehicle equipment, vehicle system does not operate normally and diagnosis cannot be performed correctly. Pay attention to following item.

Be sure to match registrations or customizing settings with vehicle equipment.
Do not change the settings of vehicle improperly.
Be sure to register immobilizer if body integrated unit is replaced with a new part. (Models without the keyless access with push button start system, and except for C0)
Make a registration of immobilizer when the parts related to immobilizer have been replaced. Refer to the "REGISTRATION MANUAL FOR IMMOBILIZER" provided as a separate article .
Confirm [Factory initial setting] of body integrated unit registrations is [Market]. (Confirm using the current data display of Subaru Select Monitor.)

On [Start] screen, select [Diagnosis].
On [Vehicle selection] screen, input the target vehicle information and select [OK].
On [Main Menu] screen, select [Each System].
On [Select System] screen, select [Body Control], and then select [Enter].
On [Select Function] screen, select [Customize].
NOTE:
For the vehicle requiring the destination setting, if the destination setting is not finished, display cannot be shifted into customizing screen. Ref. to BODY CONTROL (DIAGNOSTICS)>REGISTRATION BODY INTEGRATED UNIT>OPERATION>DESTINATION SETTING
Change the setting to the contents saved at confirmation of current setting.
CAUTION:
- To perform normal operation of vehicle and diagnosis, above settings must match the actual vehicle equipment.
- When the body integrated unit is new or in Factory mode, the room light illuminates, and user customizing is incomplete. Check the user customizing settings.
- Be sure not to change Factory initial setting except when installing a new body integrated unit.
NOTE:
"Factory" mode:
- Body integrated unit has not been set yet. For model without keyless access with push button start system, it can be recognized by key ring illumination blinking with ignition switch turned to ON. For model with keyless access with push button start system, it can be recognized by room light, map light and luggage room light blinking with ignition switch turned to ON and the switch in DOOR position.
- All replacement body integrated units are set to "Factory" mode. When replacing a body integrated unit, be sure to perform the registration operation.
"Market" mode:
- Each settings have been set. For model without keyless access with push button start system, it can be recognized by key ring illumination coming on in conjunction with room light and going off with ignition switch turned to ON. For model with keyless access with push button start system, it can be recognized by room light, map light and luggage room light not blinking with ignition switch turned to ON and the switch in DOOR position.
Perform the factory initial setting. Select [Factory initial setting] on [Customize] display of Subaru Select Monitor.
Change the mode from Factory to Market.
Turn the ignition switch to OFF to settle the setting.
Perform the customizing. Ref. to BODY CONTROL (DIAGNOSTICS)>CUSTOMIZE
Register the immobilizer. Follow the procedure of the "REGISTRATION MANUAL FOR IMMOBILIZER" provided as a separate volume. (Models without the keyless access with push button start system, and except for C0)