Inspection steps

1. Disconnect the connector D28 of the transmission control switch.
2. Check the transmission control switch unit. (Refer to UNIT INSPECTION )

NG: Replacement of transmission control switch (refer to SELECT LEVER )

OK: Go to next step

1. Disconnect the connector A19 of the transmission control computer ASSY.
2. Measure the resistance of the vehicle side connector. (For terminal arrangement, refer to ECM TERMINAL ARRANGEMENT  .)
   STANDARD VALUE RESISTANCE SPECIFICATION
   
   

   Inspection terminals	Inspection conditions	Standard value
   A19-2 (SFTU) - chassis ground	When select lever is in M position and shifted to "+"	Less than 1 Ω
   A19-1 (SFTD) - chassis ground	When select lever is in M position and shifted to "-"	Less than 1 Ω
   A19-2 (SFTU) - chassis ground	Neutral position (M position)	10 k Ω or more
   A19-1 (SFTD) - chassis ground	Neutral position (M position)	10 k Ω or more

3. Connect the connector A19 of the transmission control computer ASSY.

NG: Repair or replacement of wiring harness or connector

OK: Go to next step

1. Replace the transmission control computer ASSY. (Refer to TRANSMISSION CONTROL COMPUTER ASSY )

AT unit correction (refer to WORK SUPPORT  )