VDC Control Module Parameter Reading

Perform reading of parameter.
1. Connect the Subaru Select Monitor.
  NOTE: For detailed operation procedures, refer to "Application help".
2. Turn the ignition switch to ON.
3. On [Start] display, select [Diagnosis].
4. On [Select Vehicle] display, input the target vehicle information and select [Set].
5. On [Main Menu] display, select [Each System].
6. On [Select System] display, select [Brake Control], and then select [Enter].
7. On [Select Function] display, select [Work Support].
8. On [Work Support] display, select [Reading of parameter: ECM to SSM].
Save and close the file.