Cruise Control Command Switch: Installation

CAUTION:

Before handling the Airbag System components, Ref. to AIRBAG SYSTEM>General Description>CAUTION
Do not allow harness and connectors to interfere or get tangled up with other parts.
Make sure that the steering roll connector is not turned from the original position.
If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VSC (VDC) Centering Mode" of the VDC. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC Control Module and Hydraulic Control Unit (VDC CONTROL MODULE & H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE
Securely install the switch. Improper insertion of the pin or claw of the switch may cause improper installation.

Install the cruise control command switch assembly.
Align the center position of the steering roll connector. Ref. to AIRBAG SYSTEM>Roll Connector>ADJUSTMENT
Install the steering wheel.
Tightening torque:

39 N.m (4 kgf-m, 28.8 ft-lb)

Clearance:

Between cover assembly - column and steering wheel: 4 - 6 mm (0.16 - 0.24 in)
Install the driver's airbag module. Ref. to AIRBAG SYSTEM>Driver's Airbag Module>INSTALLATION
Connect the battery ground terminal. Ref. to NOTE>NOTE>BATTERY