LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2018 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Cruise Control System (Diagnostics)) >> Cancel Code >> Operation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Cancel Code: Operation

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. On [Start] screen, select [Diagnosis].
  2. On [Select Vehicle] screen, input the target vehicle information and select [OK].
  3. On [Main Menu] screen, select [Each System].
  4. On [Select System] screen, select [Engine], and then select [Next].
  5. Drive vehicle at 40 km/h (25 MPH) or more and set the cruise control.
    NOTE:

    When performing the entire diagnosis or cruise control diagnosis, first start the engine and wait until initial illumination of the ABS/VDC warning light completes. (If you start the diagnostics before performing the above procedures, the cancel code "43" is recorded and CRUISE indicator does not illuminate even though the CRUISE MAIN switch is pressed.) 

    CAUTION:
    • When performing diagnosis, observe the legal speed limit on the road. 
    • The cancel code will also appear when the cruise control is canceled by the driver's operation. Do not confuse them. 
    • Be sure to get an assistant to support the diagnosis while driving, and have him/her operate the select monitor. 
  6. When the set speed is canceled by itself (without any cancel operations such as applying brake) or when the cruise control could not be set by performing the setting operation, selecting the [Cancel Code] on the engine malfunction diagnosis screen will display the cancel code on the select monitor display.
    NOTE:

    The [Current] and [The past] are contained in the cancel code. The latest code recognized during current test drive is displayed in [Current]. Cancel codes resulting from fault diagnosis of switches relating to the system and cruise control are also displayed in [The past]. 

  7. Using the Subaru Select Monitor, perform the clear memory of [Engine]. Ref. to COMMON (DIAGNOSTICS)>CLEAR MEMORY

    Cancel codes for switches relating to the system and cruise control are deleted by clearing memory on [Engine]. Ref. to COMMON (DIAGNOSTICS)>CLEAR MEMORY

    NOTE:
    • The latest code will be cleared by turning ignition switch to OFF. 
    • For detailed operation procedures, refer to "Help" of application. 
    • For details on cancel codes, refer to List of Cancel Code. Ref. to  CRUISE CONTROL (DIAGNOSTICS)>CANCEL CODE>LIST  
scientia non olet · About LEMON Manuals