Security Control Module: Installation

CAUTION:

When the control module related to immobilizer has been replaced, be sure to perform the registration of immobilizer system. For detailed operation procedure, refer to "Type B" described in "REGISTRATION MANUAL FOR IMMOBILIZER".
Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>General Description>CAUTION
Do not allow harness and connectors to interfere or get tangled up with other parts.
If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VSC(VDC) Centering Mode" of the VDC. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC Control Module and Hydraulic Control Unit (VDC CONTROL MODULE & H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE

Install the security control module.
Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
Install the heater and cooling unit assembly. Ref. to HVAC SYSTEM (HEATER, VENTILATOR AND A/C)>Heater and Cooling Unit>INSTALLATION
Install the instrument panel assembly. Ref. to EXTERIOR/INTERIOR TRIM>Instrument Panel Assembly>INSTALLATION
Install the knee airbag module. Ref. to AIRBAG SYSTEM>Knee Airbag Module>INSTALLATION
Install the cover assembly - instrument panel LWR driver. Ref. to EXTERIOR/INTERIOR TRIM>Instrument Panel Lower Cover>INSTALLATION
Install the steering wheel. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>Steering Wheel>INSTALLATION
Connect the battery ground terminal. Ref. to NOTE>NOTE>BATTERY