Seat Ventilation Control Module

CAUTION:

Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
The load sensor of the occupant detection system is fixed to the cushion frame assembly. Never remove the load sensor from the cushion frame assembly. The following parts can be replaced as a single unit.
- Cushion pad
- Cushion cover
- Occupant detection control module
- Seat harness
When the cushion frame assembly of the passenger's seat is replaced, the occupant detection control module, seat harness and load sensor are assembled. When replacing the cushion frame assembly, do not touch the load sensor to avoid electrical damage.
When removing or replacing the seat, perform "Occupant Detection System Inspection" after installing the seat to check if the occupant detection system operates normally. Ref. to PRE-DELIVERY INSPECTION>PRE-DELIVERY INSPECTION (PDI) PROCEDURE>SEAT .

Install the seat ventilation Control Module.
CAUTION: Set the height of rivet crimped section as 3 mm (0.12 in). If the crimp is not sufficient, press them with pliers, etc. in order to avoid interfering with the door trim.

Preparation tool and item:

Hand riveter (corresponding to 4.0 mm (0.16 in))

Rivet
Assemble the front seat. Ref. to SEATS>FRONT SEAT>ASSEMBLY .
Install the front seat. Ref. to SEATS>FRONT SEAT>INSTALLATION .
Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Perform [Rezeroing] for the occupant detection system. Ref. to OCCUPANT DETECTION (DIAGNOSTICS)>REZERO .