LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle (Service Information) >> Select Lever >> Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Select Lever: Assembly

  1. Installation of swivel
    1. Install the 2 washers, spacer, bushing, and swivel with a snap pin.
      G12587524Courtesy of SUBARU OF AMERICA, INC.
  2. Installation of gasket
    1. Install 4 spacer plates and the gasket.
      G12587525Courtesy of SUBARU OF AMERICA, INC.
  3. Installation of select arm bracket
    1. Apply Multemp D to the spring and the rod.
    2. Install the spring and the rod to the select arm bracket.
      G08554455Courtesy of SUBARU OF AMERICA, INC.
    3. Apply Multemp D to the select lever COMPL and the select arm bracket.
      G08554456Courtesy of SUBARU OF AMERICA, INC.
    4. Apply Multemp D to the sliding surface of the rod and install the select arm bracket to the select lever COMPL.
      G08554457Courtesy of SUBARU OF AMERICA, INC.
  4. Installation of select lever COMPL
    1. Set the select arm bracket together with the select lever COMPL as a single unit to the base plate.
      G12587529Courtesy of SUBARU OF AMERICA, INC.
  5. Installation of arm COMPL
    1. Insert the arm COMPL to the base plate.
      G12587530Courtesy of SUBARU OF AMERICA, INC.
    2. Use a pin punch 3 and hammer to drive in a new pin.
      G12587531Courtesy of SUBARU OF AMERICA, INC.
  6. Installation of grommet
    1. Install the grommet.
      G12587532Courtesy of SUBARU OF AMERICA, INC.
  7. Installation of D rod
    1. Install the bushing D lock.
    2. Install the cushion detent lock to the D rod.
    3. Apply Multemp D to the D lock spring and the D rod.
    4. Install the D lock spring and the D rod.
    5. Install the D lock clamp.
      G12587533Courtesy of SUBARU OF AMERICA, INC.
  8. Installation of solenoid unit
    1. Apply Multemp D to the solenoid unit and the pin.
    2. Set the solenoid unit together with the shift lock release arm as a unit to the base plate and insert the pin.
      G12587534Courtesy of SUBARU OF AMERICA, INC.
  9. Installation of guide plate
    1. Engage the 2 claws and install the guide plate to the base plate.
      G12587535Courtesy of SUBARU OF AMERICA, INC.
    2. Install the shaft guide pin and a new clamp push nut.
      G12587536Courtesy of SUBARU OF AMERICA, INC.
    3. Connect the connectors No. 2 and No. 3 of the shift lock solenoid connector and the connectors No. 10 and No. 11 of the manual mode switch connector.
      G12587537Courtesy of SUBARU OF AMERICA, INC.
    4. Lock the terminal of the harness connector.
      G12587538Courtesy of SUBARU OF AMERICA, INC.
    5. Engage the claw and install the connector.
      G12587539Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals