LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2019 >> Outback 2.5i >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Lubrication System (3.6L)) >> Oil Level Switch >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Oil Level Switch: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Route the oil level switch harness as shown in the figure.
    G13248474Courtesy of SUBARU OF AMERICA, INC.
  2. Attach the oil level switch to the oil pan upper.
    NOTE:
    • Use new O-rings.
    • Apply a coat of engine oil to the O-rings.

    Tightening torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

  3. Connect the connector of the oil level switch to the engine harness, and install the clips securing the harness to the front camshaft cap (LH) and the cylinder head (LH).
  4. Install the undercover, Ref. to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER>INSTALLATION .
  5. Lower the vehicle.
  6. Fill engine oil. Ref. to LUBRICATION (H6DO)>Engine Oil>REPLACEMENT .
  7. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals