Service Inspection: Connection
On Service Menu, click "Connection" to display the following items.
OK: Each connection device is connected properly.
NG: Connection is not established, or connection status (including harness) is faulty.
NOTE:
Check the external connection terminals (USB 1, USB 2 and AUX) by connecting memory or a pin jack for inspection.
Check the connection status of the connector and harness. If there are no problems, the connection device or unit could be faulty.
The following shows information to be displayed and its description.
Check the connection status of the connector and harness. If there are no problems, the connection device or unit could be faulty.
The following shows information to be displayed and its description.
| Item | Item detection method | OK judgment condition | Note |
|---|---|---|---|
| GPS | Direct line | GPS antenna is connected. (NG is displayed when short circuit is detected.) | With navigation n only |
| MIC | Direct line | (i87) No. 6 falls to GND level. | - |
| Rr_CAM | Direct line | Synchronized signals from the camera are input to (i146) No. 3. | - |
| AUX | Direct line | (i87) No. 25 falls to GND level. | - |
| USB 1 | Communication | USB device is connected to USB-HUB to obtain USB device information properly. (Should be recognizable as a supported USB device.) | - |
| USB 2 | Communication | USB device is connected to USB-HUB to obtain USB device information properly. (Should be recognizable as a supported USB device.) | - |
| SXM | Direct line | XM-ANT is connected. (NG is displayed when short circuit is detected.) | It takes approx. 30 seconds to become recognize able. |
| Leather AMP | Communication | AMP is connected and normal communication is available. | - |