Camera All Initialization
WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
This is a recovery measures prepared for the data failure caused by the low battery voltage during data storage to inside the stereo camera.
CAUTION:
Do not usually perform camera initialization because it will clear the camera adjustment and inspection data and/or diagnostic codes.
Perform the procedure only when the camera adjustment and inspection result is NG even if the vehicle parked position is normal as shown in the flowchart described in "Procedure". After camera all initialization, perform camera adjustment and inspection in the same procedure as for camera replacement.
- Turn the ignition switch to ON and wait for approx. 10 seconds.
- Using Subaru Select Monitor, perform [EyeSight All Initialization] in the [Work Support] of [EyeSight]. Ref. to COMMON (DIAGNOSTICS)>WORK SUPPORT
- After [Do not usually perform "EyeSight all initialization" because it will clear vehicle registration information, aiming data, diag codes, cancellation codes, etc. After implementing EyeSight all initialization, if necessary, please carry out "Clear Adjustment Value", Vehicle information registration", Aiming" etc. according to "Service Information". Do you really want to do it?] is displayed, select [Yes].
- When ["EyeSight all initialization" Processing Please wait] is displayed, wait until it finishes.
- ["EyeSight all initialization" completed normally. 1) Please IG switch or key switch to OFF. 2) Wait for 5 seconds. 3) Click the OK button, exit SSM4.] is displayed after EyeSight all initialization is successfully completed, select [OK] to exit.
- Turn the ignition switch to OFF and wait for 5 seconds.