Inspection Mode A
| DTC | Item | Condition | Number of driving cycles on the detecting condition |
|---|---|---|---|
| P0459 | EVAP SYSTEM (CPC) PURGE CONTROL VALVE "A" CIRCUIT HIGH | - | 2 |
WARNING:
When performing inspection mode A on a public road, pay sufficient attention to the traffic condition and give the highest priority to safe driving.
NOTE:
Perform the inspection mode after warming up the engine except that the engine coolant temperature at engine start is specified.
- Check that the battery voltage is 12 V or more and fuel remains approx. half [20 - 40 L (5.3 - 10.6 US gal, 4.4 - 8.8 Imp gal)].
- Using the Subaru Select Monitor, perform the clear memory of [Engine]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
- Drive for 20 minutes or more at a constant speed of 80 km/h (50 MPH) or more.
- Stop the vehicle and idle for one minute.
- Read the readiness code of [Engine] using Subaru Select Monitor and check that the concerned self diagnosis is completed. Ref. to ENGINE (DIAGNOSTICS) (H4DO (HEV))>ALL READINESS DIAGNOSTIC CODE(S) .
- Read the temporary code using the Subaru Select Monitor or general scan tool. Ref. to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC) .