LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2020 >> Forester Base >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Body Control System (Diagnostics) >> Registration Body Integrated Unit >> Operation >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Registration Body Integrated Unit: Operation: Notes

  1. CONFIRM CURRENT SETTING 
    1. On [Start] screen, select [Diagnosis].
    2. On [Vehicle selection] screen, input the target vehicle information and select [OK].
    3. On [Main Menu] screen, select [Each System].
    4. On [Select System] screen, select [Body Control], and then select [Enter].
    5. On [Select Function] screen, select [Customize].
    6. Save the setting.
REQUIRED ITEMS FOR NEW REGISTRATION (EXCEPT FOR SYSTEM NOT EQUIPPED)

Item Contents Remarks
Off delay time OFF 10 Sec 20 Sec 30s -
Auto Light Sensitivity Adjustment Dull Normal Sensitive Very sensitive -
Remote Trunk Open/Power Rear Gate Open Function (ON/OFF) ON OFF -
Power rear gate setting Exist Not Exist -
Lane change signal setting Exist Not Exist -
Rear wiper auto setting Exist Not Exist -
Driver's Door Unlock Setting ALL Selection Option setting
Rear Gate Unlock Setting ALL Selection Option setting
Daytime Running Light (DRL) Setting for North America High Beam Dimming System Low Beam Dimming System Alternate DRL System -
Wiper link Auto Light Setup ON OFF -
Steering Wheel Left Right -
Vehicle Automatic Door Lock OFF Vehicle Speed Select Lever P -
Vehicle Automatic Door Unlock OFF Select Lever P Power OFF Driver Door Open -
P/W ECU Setting No Support Driver Seat Driver/Passenger Seat Four Seat -
Sunshade ECU Setting Exist Not Exist -
Steering Responsive Fog Lamp Setting Exist Not Exist -
Ambient Light Setting Exist Not Exist -
Ambient Light Setup OFF ON -
Head Lamp Low Beam Specification Halogen HID LED Customizing setting values do not affect the vehicle behavior.
Therefore, keep the initial setting values.
Head Lamp High Beam Specification Halogen HID LED Customizing setting values do not affect the vehicle behavior.
Therefore, keep the initial setting values.
High Beam Assist Current Setting ON OFF Option setting
High Beam Assist Function Setting (mirror/EyeSight) Not Exist mirror HBA EyeSight HBA -
Rr Defogger op. mode Normal Continuous -
Security Alarm Setup ON OFF -
Impact Sensor Setup ON OFF Set to OFF.
Alarm delay setup ON OFF -
Lockout prevention ON OFF -
Impact sensor Exist Not Exist Set to No.
Answer-back buzzer setup ON OFF -
Hazard answer-back setup ON OFF -
Door open warning Exist Not Exist -
Dome Light Alarm Setting ON OFF -
Auto A/C Setting Active OFF -
wiper deicer Exist Not Exist -
Sedan/Wagon Setting Wagon Sedan -
MT/AT Setting MT AT -
Rain drop Detection Sensor Setting Exist Not Exist -
Seat Memory Setting Exist Not Exist -
Illumination Sensor Setting Exist Not Exist -
Factory initial setting Factory Market Do not set to Factory mode.
Auto Wiper/INT Setting AUTO INT -
EPB setting Exist Not Exist -
Sunroof setting Exist Not Exist -
Welcome Light Off Delay Time (Approaching) OFF 30 seconds 60 seconds 90 seconds -
Welcome Lighting (Exiting) OFF 30 seconds 60 seconds 90 seconds -
Keyless Buzzer Volume 1234567 -
Auto Dimmer Cancel Setting 0 (OFF) Least Less Normal More Most -