Check Rear Gate Opener Button Circuit

Display the [R Gate Release SW input] data using Subaru Select Monitor. Refer to BODY CONTROL (DIAGNOSTICS)>DATA MONITOR>OPERATION .

Does the display change to [OFF] ←→ [ON], when the rear gate opener button is operated?

Yes

Rear gate opener button is normal.

No

Go to  2.

1. Disconnect the connectors of body integrated unit and rear gate opener button.
2. Check the harness between the body integrated unit and rear gate opener button.

Connector & terminal 

Model without keyless access with push button start 

(i171) No. 6 - (D47) No. 1:

Model with keyless access with push button start 

(i171) No. 6 - (D77) No. 1:

Is harness normal?

Yes

Go to  3.

No

Repair or replace the harness.

Measure the resistance between the rear gate opener button connector and chassis ground.

Connector & terminal 

Model without keyless access with push button start 

(D47) No. 2 - Chassis ground:

Model with keyless access with push button start 

(D77) No. 2 - Chassis ground:

Is the resistance less than 10 Ω?

Yes

Go to  4.

No

Repair or replace the harness.

Measure the resistance between terminals both when the rear gate opener button is pressed and when not pressed.

Terminals 

No. 1 - No. 2:

Is the resistance less than 10 Ω when the switch is pressed and 1 MΩ or more when not pressed?

Yes 

Replace the body integrated unit. Refer to SECURITY AND LOCKS>BODY INTEGRATED UNIT .

No

Replace the rear gate opener button.