LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2020 >> Legacy Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Fuel Injection System (2.4L)) >> Engine Coolant Temperature Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Coolant Temperature Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Set a new gasket, install the engine coolant temperature sensor using the ST.
    NOTE: STRUT MOUNT SOCKET (20099PA000) can also be used.

    Preparation tool: 

    ST: STRUT MOUNT SOCKET (20399AG000)

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.3 ft-lb)

  2. Connect the connector (B) to engine coolant temperature sensor and connect the connector (A) to the knock sensor.
    G13198271Courtesy of SUBARU OF AMERICA, INC.
  3. Install the connector (A) and clip (B).
    G13198270Courtesy of SUBARU OF AMERICA, INC.
  4. Install the clip (D) and clip (E), and connect the connector (A), connector (B) and connector(C).
    G13619638Courtesy of SUBARU OF AMERICA, INC.
  5. Install the intercooler. Refer to INTAKE (INDUCTION) (H4DOTC)>Intercooler>INSTALLATION .
  6. Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
  7. Fill engine coolant. Refer to COOLING (H4DOTC)>Engine Coolant>REPLACEMENT>FILLING OF ENGINE COOLANT .
scientia non olet · About LEMON Manuals