Basic Diagnostic Procedure: Procedure

Ask the customer when and how the trouble occurred using the interview check list. Refer to MULTI VIEW MONITOR (DIAGNOSTICS)>Check List for Interview .

Did you interview the customer?

Yes  : Go to  2.

No  : Perform the interview, and Go to  2.

Perform basic inspection.

Is the check result OK?

Yes  : Go to  3.

No  : Repair the faulty part found in basic inspection, and Go to  3.

1. Turn the ignition switch to OFF.
2. Connect the Subaru Select Monitor to data link connector. Refer to COMMON (DIAG)>DATA LINK CONNECTOR .
3. Turn the ignition switch to ON and run the Subaru Select Monitor.
4. Select [Multi View Monitor].

Is communication possible?

Yes  : Go to  4.

No  : Check the communication circuit. Refer to MULTI VIEW MONITOR (DIAGNOSTICS)>Diagnostic Procedure for Subaru Select Monitor Communication .

Read the DTC of [Multi View Monitor] using the Subaru Select Monitor. Refer to MULTI VIEW MONITOR (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .

Are any DTCs displayed? (Current malfunction)

Yes  : Record the DTC, time stamp and freeze frame data, and go to next. Go to  5.

No  : Perform diagnosis according to the procedures in the diagnostics with phenomenon. Refer to MULTI VIEW MONITOR (DIAGNOSTICS)>Diagnostics with Phenomenon .

1. Perform the diagnosis for the displayed DTCs. Refer to MULTI VIEW MONITOR (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .
2. Repair or replace the cause of trouble.
3. Using the Subaru Select Monitor, perform the clear memory of [Multi View Monitor]. Refer to COMMON (DIAG)>CLEAR MEMORY .
4. Execute the inspection mode. Refer to MULTI VIEW MONITOR (DIAGNOSTICS)>Inspection Mode .
5. Read the DTC of [Multi View Monitor] using the Subaru Select Monitor. Refer to MULTI VIEW MONITOR (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .

   Are any DTCs displayed? (Current malfunction)

   Yes  : Repeat step 5 until DTC is not shown.

   No  : Finish the diagnosis.