Line Pressure Sensor: Installation

CAUTION: If water or oil contacts the connector terminal of line pressure sensor, replace it with a new part.

Install the line pressure sensor using a new O-ring, and connect the connector.
NOTE: Apply CVTF to the O-rings.

Tightening torque:

13 N.m (1.3 kgf-m, 9.6 ft-lb)
Install the crossmember support rear LH. Refer to EXHAUST (H4DO)>Front Exhaust Pipe>INSTALLATION .
Install the front wheel LH. Refer to WHEEL AND TIRE SYSTEM>Tire and Wheel>INSTALLATION .
Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
Check the CVTF level. Refer to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>CVTF>INSPECTION .