LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2020 >> Outback Limited XT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Fuel Injection System (2.5L)) >> Engine Control Module (ECM) >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Control Module (ECM): Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
  2. Disconnect the connector in numerical order as shown in the figure.
    CAUTION: Make sure that the lock is released before moving the lever in order to avoid damaging the connector.
    NOTE: To disconnect the connector, press the portion (a) shown in the figure to release the lock and move the lever in the direction of arrow.
    G13223989Courtesy of SUBARU OF AMERICA, INC.
    G13618521Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the ECM from vehicle.
    G13223991Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the ECM bracket.
scientia non olet · About LEMON Manuals