Pre-Delivery Inspection (PDI) Procedure: Notes

Perform the procedures indicated in the table below.

Static checks just after vehicle receipt

Item	Check point
1. Appearance	If the vehicle is covered with protective film, visually check the vehicle body for damage and dents. If the protective film has been removed, visually check the painted body surfaces in detail for damage or rust. Visually check the glass and light lenses for any damage, cracks or excessive gaps between body sheet metal. Visually check the plated parts for any damage. Check the instrument panel, console and trim for stains or dirt.
2. Tire	Check the tires for damage, defective, and dents on wheels. Check the tire air pressure.
3. Fuse installation	If the vehicle is about to be delivered to customer, attach a delivery mode fuse to the back-up fuse holder.
4. Door lock/unlock and open/close operations	Using the key, check the door can be locked or unlocked normally. Open and close all doors to check that there are no problems. Operate the power door lock switch to check that all doors and the rear gate lock and unlock normally.
5. Child safety lock	Check the child safety lock system operates normally.
6. Trunk lid open/close operations	Operate the trunk lock release lever to check that the trunk lid opens normally. Open and close the trunk lid to check that there are no problems.
7. Rear gate lock/unlock and open/close operation	Check if the rear gate can be unlocked normally through the emergency hole. Open and close the rear gate to check that there are no problems. Operate the power door lock switch to check that all doors and the rear gate lock and unlock normally.
8. Operation check of trunk lid release lever	Operate the trunk lid release lever to check that the trunk lock is unlocked normally.
9. Fuel lid opener lever (except for hybrid model)	Operate the fuel lid opener to check that the fuel lid is unlocked normally.
10. Fuel lid lock/unlock and open/close operation (hybrid model)	Press the fuel lid opener switch to check that the fuel lid is unlocked normally. Check the fuel lid can be unlocked normally by using an emergency release cable.
11. Charging inlet door and charging connector (hybrid model)	Check the charging inlet door unlocks normally. With unlock condition, check the charging inlet door opens normally. Insert the charge cable into the device side, and check the charging indicator illuminates. Check the charging connector locks and unlocks normally. Check the charging inlet door and charging connector unlock normally using the emergency unlock function.
12. Towing hook (eyebolt) (Crosstrek model)	At factory shipment, the towing hook (eyebolt) is installed to the rear bumper. Remove the towing hook (eyebolt), and store it in the holder. Install the supplied rear hook cover to the vehicle.
13. Accessory	Check that the following accessories are equipped. Owner's manual Warranty booklet Maintenance note Spare key Key No. plate Jack Jack handle Tool set Charge cable Spare tire or puncture repair kit Towing hook (eyebolt)
14. Front hood lock release	Operate the front hood lock release lever to check that the front hood opens normally.
15. Battery	Check the battery for any abnormal conditions such as rust or traces of battery fluid leaks. (Including battery (12 V))
16. HV battery cooling air intake	Check that no dirt or fluid is adhered or mixed in.
17. Electric vehicle charger assembly cooling exhaust	Check that no dirt or fluid is adhered or mixed in.
18. HV battery smoke emission duct vehicle outside discharge port	Check that no dirt or fluid is adhered or mixed in.
19. Brake fluid	Check the brake fluid amount.
20. Engine oil	Check the engine oil amount.
21. Transmission gear oil	Check that the transmission gear oil level is normal.
22. CVTF	Check for leakage of CVTF.
23. ATF	Check for leakage of the ATF.
24. Front differential gear oil	Check for leakage of front differential gear oil.
25. Rear differential gear oil	Check for leakage of gear oil from the rear differential.
26. Engine coolant (engine side)	Check the engine coolant (engine side) level.
27. Engine coolant (inverter assembly side)	Check the engine coolant (inverter assembly side) level.
28. Clutch fluid	Check the clutch fluid amount.
29. Window washer fluid	Check the window washer fluid amount.
30. Front hood latch	Check that the front hood is closed normally and locked securely.
31. Keyless entry system	Check that the keyless entry system operates normally.
32. Keyless access system	Check that the keyless access system operates normally.
33. Alarm system	Check that the alarm system including front hood security system operates normally.
34. Seat	Check the seat surfaces for stains or dirt. Check the seat installation conditions and functionality. Check that the seat heater system operates normally.
35. Seat belt	Check the seat belt installation conditions and functionality. Check the seat belt warning system operates normally.
36. TPMS (U.S. model)	If the display of TPMS warning light does not operate normally, perform the diagnosis by referring to TPMS (Diagnosis).
37. Grommet installation	Use the following procedures to install the grommet. Install the grommet provided on the rear seat to the rear tie-down hole. (Crosstrek model)

Item	Check point
38. Delivery mode	Turn the ignition switch to ON and check that the malfunction indicator light starts blinking.
39. Immobilizer system	Check that the engine starts with all keys that are equipped on vehicle. Check that the security indicator light operates normally.
40. Push button start	Using the access key that is equipped on vehicle, operate the push button start function to check engine start and stop operations.
41. Starting condition	Start the engine and check that the engine starts smoothly.
42. Exhaust system	Check that there are no abnormal exhaust noises and exhaust gas leaks.
43. Indicator and warning lights	Check that all indicator lights and warning lights are operating correctly.
44. Heater & ventilation	Check that the heater & ventilation system operates normally.
45. Air conditioner	Check that the air conditioner operates normally.
46. Multi-function display (MFD)	Check that the Multi-Function Display (MFD) function operates normally.
47. Audio	Check the radio and AUX operate normally.
48. Navigation	Check the navigation and AUX operate normally.
49. Telematics system	Check that the indicator light on the overhead console or on the stereo camera cover assembly goes off. Perform the Bluetooth connection procedure between head unit (without navigation) and smartphone.
50. Accessory power supply socket	Check that the accessory power supply socket operates normally.
51. Lighting system	Check that the lighting system operates normally.
52. Illumination control	Check that the illumination control operates normally.
53. Window washer system	Check that the window washer system operates normally.
54. Wiper system	Check that the wiper system operates normally.
55. Wiper deicer	Check that the wiper deicer operates normally.
56. Power window	Check that the power window operates normally.
57. Sunroof	Check that the sunroof operates normally.
58. Rear defogger system	Check that the rear defogger system operates normally.
59. Door mirror	Check that the remote control mirror and heated mirror operate normally.
60. Steering heater	Check that the steering heater operates normally.
61. Blind Spot Detection/Rear Cross Traffic Alert (BSD/RCTA)	Press the BSD/RCTA OFF switch several times to check that the system is activated and deactivated correctly. Check the rear bumper around the sensor for dirt, scratch, affixed stickers and poor paint coating.
62. Reverse Automatic Braking (RAB)	Check that the RAB system is activated and deactivated correctly. Check the sonar sensor installed on the rear bumper for parts missing, dirt, scratch, foreign objects, etc.
63. Front view monitor	Check that the front view monitor operates normally.
64. Diagnostic trouble code (DTC) check	Check that the diagnostic trouble code (DTC) is not detected.
65. Driver assist indicator	Check the driver assist indicator operates normally.

Item	Check point
66. Brake test	Check the foot brake for normal operations.
67. Parking brake	Check that the parking brake operates normally.
68. Shift control	Check that the shift patterns are correct.
69. Cruise control	Check that the cruise control system operates normally.
70. Subaru EyeSight	Check that the Subaru EyeSight operates normally.
71. Hybrid system	Check that the hybrid system operates normally.
72. EV (Electric Vehicle) mode light	Check the EV (Electric Vehicle) mode light operates normally.

Item	Check point
73. Power steering system (electric power steering model)	Check the steering warning light operation.
74. Fluid leakage	Check for fluid/oil leaks.
75. Water leak test	Spray the vehicle with water and check for water leaks.
76. Appearance 2	Remove the protective film (if equipped). Check the body paints for damage and stain. Check the plated parts for damage and rust.