Inspection Mode 1
| DTC | Item | Note |
|---|---|---|
| B1401 | COMBINATION METER COLLATION | - |
| B1402 | IMMOBILIZER KEY COLLATION | - |
| B1407 | COMBINATION METER COMMUNICATION | - |
| B1408 | COMBINATION METER NON-VOLATILE MEMORY | - |
| B1410 | TRANSPONDER COMMUNICATION | - |
| B1411 | IMMOBILIZER ANTENNA | - |
| B1413 | IMMOBILIZER CONTROL MODULE BATTERY POWER SUPPLY | - |
Diagnostic procedure:
- Using the Subaru Select Monitor, perform the clear memory of [Body Control] or [Immobilizer]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
- Read the DTC of [Body Control] or [Immobilizer] using Subaru Select Monitor and check that the DTC is not displayed. Ref. to IMMOBILIZER (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs. After solving the DTC, repeat from step 1).
- Remove the ignition key from the ignition switch, and insert again.
- Turn the ignition switch OFF - ON, and wait for 10 seconds or more.
- Read the DTC of [Body Control] or [Immobilizer] using Subaru Select Monitor and check that the DTC is not displayed. Ref. to IMMOBILIZER (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs.