Memory Height Switch: Inspection
- Measure the resistance between switch terminals.
Preparation tool:
Circuit tester
Terminal No. Inspection conditions Standard 1 - 4 Switch OFF 1 MΩ or more Switch ON Less than 1 Ω - Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.CAUTION: When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.
Incorrect polarity connection may cause LED damage inside the switch.Terminal No. Inspection conditions Specification 2 (+) - 3 (-) Apply battery voltage. Light On - Replace the memory height switch, if the inspection result is not within the standard value.