Work Support: Operation

If the power seat control module is replaced, it is possible to read the information on setting the user performed using Subaru Select Monitor and write to the new power seat control module.

NOTE:

Never write the data into the vehicle other than the original vehicle that the data was read from.
After the ECM setting information writing is completed, perform the power seat control module initialization operation.

Execution condition:

When the driver's seat assembly equipped with the power seat control module with seat positions memorized or the power seat control module was replaced.

Read Control module setting information
1. On [Start] screen, select [Diagnosis].
2. On [Select Vehicle] screen, input the target vehicle information and select [OK].
3. On [Main Menu] screen, select [Each System].
4. On [Select System] screen, select [Power Seat Memory], and then select [Next].
5. On [Select Function] screen, select [Work Support].
6. On [Work Support] screen, select [Read Control module setting information].
7. According to the display screen, save and close the file.
Write ECU setting save data
1. On [Start] screen, select [Diagnosis].
2. On [Select Vehicle] screen, input the target vehicle information and select [OK].
3. On [Main Menu] screen, select [Each System].
4. On [Select System] screen, select [Power Seat Memory], and then select [Next].
5. On [Select Function] screen, select [Work Support].
6. On [Work Support] screen, select [Write ECU setting save data].
7. Perform the operation according to the display screen.