DTC P0685: ECM/Pcm Power Relay Control Circuit/Open: Notes

1. - 

DTC detecting condition: 

Detected when two consecutive driving cycles with fault occur.

Wiring diagram: 

Engine Electrical System Ref. to WIRING SYSTEM>ENGINE ELECTRICAL SYSTEM .

Courtesy of SUBARU OF AMERICA, INC.

1. CHECK ECM CONNECTOR  .

   Check the connecting condition of ECM connector.

   Is the ECM connector correctly connected?

   Yes  : Go to  2 .

   No  : Connect the ECM connector correctly.

2. CHECK HARNESS BETWEEN ECM AND M/B (MAIN RELAY) (SHORT TO GROUND)  .
   1. Turn the ignition switch to OFF.
   2. Remove the main relay.
   3. Disconnect the connector from ECM.
   4. Measure the resistance between the ECM connector and engine ground.

      Connector and terminal 

      (B62) No. 12 - Engine ground:

   Is the resistance 1 MΩ or more?

   Yes  : Go to  3 .

   No  : Repair the short circuit to ground in harness between ECM connector and M/B (main relay).

3. CHECK HARNESS BETWEEN ECM AND M/B (MAIN RELAY) (SHORT TO POWER SUPPLY)  .
   1. Turn the ignition switch to ON.
   2. Measure the voltage between ECM connector and engine ground.

      Connector and terminal 

      (B62) No. 67 (+) - Engine ground (-):

      (B62) No. 68 (+) - Engine ground (-):

   Is the voltage 10 V or more?

   Yes  : Repair the short circuit to power supply in harness between ECM connector and M/B (main relay).

   No  : Go to  4 .

4. CHECK MAIN RELAY  .
   1. Turn the ignition switch to OFF.
   2. Check the main relay. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>MAIN RELAY .

   Is the check result OK?

   Yes  : Repair the poor contact of ECM connector.

   No  : Replace the main relay. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>MAIN RELAY .