Memory Height SW Does Not Function

NOTE: Before performing diagnosis, initialize the power rear gate system by opening the power rear gate in manual operation, and then operating the power rear gate auto closer in the partially latched state.

CHECK CENTER INFORMATION DISPLAY .
Operate the memory height SW and check if the display for the memory height SW changes.

Does the display change?

Yes: The circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

No: Go to 2 .
CHECK DATA MONITOR .
Using the Subaru Select Monitor, check the following items in the [Data Monitor] of [Power Rear Gate]. Ref. to Power Rear Gate (Diagnostics)>Data Monitor .
- Memory stop SW
Does the display switch between [OFF] ←→ [ON] according to memory height SW operation?

Yes: Input circuit is normal. Perform the inspection according to the diagnosis for cockpit control system. Ref. to COCKPIT CONTROL (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .

No: Replace Power rear gate control module. Ref. to POWER REAR GATE SYSTEM>POWER REAR GATE CONTROL MODULE .