Basic Diagnostic Procedure: Procedure

PERFORM CUSTOMER INTERVIEW .
Ask the customer when and how the trouble occurred using the interview check list. Ref. to Combination Meter (Diagnostics)>Check List for Interview .

Did you interview the customer?

Yes: Go to 2 .

No: Perform the interview, and Go to 2 .
PERFORM BASIC INSPECTION .
Perform basic inspection. Ref. to COMBINATION METER (DIAGNOSTICS)>General Description>INSPECTION .

Is the check result OK?

Yes: Go to 3 .

No: Repair the faulty part found in basic inspection, and Go to 3 .
CHECK SUBARU SELECT MONITOR COMMUNICATION .
1. Turn the ignition switch to OFF.
2. Connect the Subaru Select Monitor to data link connector. Ref. to COMMON (DIAG)>DATA LINK CONNECTOR .
3. Turn the ignition switch to ON and run the Subaru Select Monitor.
4. Select [Combination Meter].
  NOTE: For detailed operation procedures, refer to "Help" of application.
Is communication possible?

Yes: Go to 4 .

No: Check the communication circuit. Ref. to Combination Meter (Diagnostics)>Diagnostic Procedure for Subaru Select Monitor Communication .
CHECK CAN COMMUNICATION .
Perform the diagnosis for LAN system. Ref. to LAN SYSTEM (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE .

Is the check result OK?

Yes: Go to 5 .

No: Perform the diagnosis for LAN system.
CHECK COMBINATION METER .
Read the DTC of [Combination Meter] using the Subaru Select Monitor. Ref. to Combination Meter (Diagnostics)>Diagnostic Trouble Code (DTC) .

Are any DTCs displayed? (Current malfunction)

Yes: Record the DTC, time stamp and freeze frame data, and Go to 7 .

No: Go to 6 .
CHECK COMBINATION METER .
Check the operation of combination meter. Ref. to Combination Meter (Diagnostics)>Active Test .

Is the operation of combination meter OK?

Yes: System is normal.

No: Replace the combination meter. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER .
PERFORM DIAGNOSIS .
1. Perform the diagnosis for the displayed DTCs. Ref. to COMBINATION METER (DIAGNOSTICS)>Diagnostic Trouble Code (DTC)>LIST .
2. Repair or replace the cause of trouble.
3. Using the Subaru Select Monitor, perform the clear memory of [Combination Meter]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
4. Execute the inspection mode. Ref. to Combination Meter (Diagnostics)>Inspection Mode .
5. Read the DTC of [Combination Meter] using the Subaru Select Monitor. Ref. to Combination Meter (Diagnostics)>Diagnostic Trouble Code (DTC) .
Are any DTCs displayed? (Current malfunction)

Yes: Repeat step 7 until DTC is not shown. Go to 7 .

No: Finish the diagnosis.