LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2021 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Instrumentation System & Driver Information Center) >> Combination Meter >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Combination Meter: Installation

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to  AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION 

  1. Connect the connector and install the combination meter assembly.
  2. Install the visor assembly.
  3. Install the panel starter switch. (Model with push button ignition starter) Ref. to SECURITY AND LOCKS>PUSH BUTTON IGNITION SWITCH>INSTALLATION
  4. Install the cover starter switch. (Model without push button ignition starter)
  5. Install the panel assembly center and the ornament panel mid passenger. Ref. to EXTERIOR/INTERIOR TRIM>CENTER CLUSTER>INSTALLATION
  6. Install the light holder driver.
  7. Install the cover LWR driver. Ref. to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>INSTALLATION
  8. Install the ornament panel mid driver assembly and cover assembly instrument panel side LH. Ref. to AIR CONDITIONER>AIR VENT GRILLE>INSTALLATION>SIDE GRILLE
  9. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
  10. When the combination meter assembly was replaced with a new part, perform the variant work. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER>REPLACEMENT>VARIANT WORK 
scientia non olet · About LEMON Manuals