LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2022 >> Ascent Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Lighting System) >> Combination Switch (Light) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Combination Switch (Light): Installation

WARNING: This page is about a different car, the 2021 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>General Description>CAUTION .
  • Do not allow harness and connectors to interfere or get tangled up with other parts.
  • If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position.
  • If the steering wheel and the sensor assembly VDC steering (steering roll connector) are removed, perform "VDC SENSOR MIDPOINT SETTING MODE" of the VDC. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC Control Module and Hydraulic Control Unit (VDCCM&H/Lh>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE .
  1. Install the switch assembly combination turn dimmer.
    1. Using pliers, loosen the clamp.
    2. While the clamp is loose, insert the switch assembly combination turn dimmer so that its claw is engaged with the cutout of the column cover assembly.
    3. Install the clamp, and connect the connector.
      NOTE: When replacing with a new part, engage the claw first, and then pull out the securing pin of the clamp.
  2. Install the steering roll connector, Ref. to AIRBAG SYSTEM>Roll Connector>INSTALLATION .
  3. Install the column cover assembly and the switch assembly combination wiper select, Ref. to WIPER AND WASHER SYSTEMS>Combination Switch (Wiper)>INSTALLATION .
  4. Install the steering wheel. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>Steering Wheel>INSTALLATION .
  5. Install the driver's airbag module. Ref. to AIRBAG SYSTEM>Driver's Airbag Module>INSTALLATION .
  6. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .