LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2022 >> Ascent Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Lighting System) >> Rear Finisher Assembly >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Finisher Assembly: Installation

WARNING: This page is about a different car, the 2021 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the finisher assembly rear.

    Tightening torque: 

    4.5 N.m (0.5 kgf.m, 3.3 ft.lb)

  2. Install the garnish assembly rear gate.

    Tightening torque: 

    4.5 N.m (0.5 kgf.m, 3.3 ft.lb)

  3. Install the motor assembly rear wiper, Ref. to WIPER AND WASHER SYSTEMS>Rear Wiper Motor>INSTALLATION .
  4. Install the sensor touch assembly. (Model with power rear gate)
  5. Install the cover rear gate. (Model without power rear gate)
  6. Install the trim panel assembly rear gate.
  7. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals