Inspection Mode 7
WARNING: This page is about a different car, the 2021 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
| DTC | Item | Note |
|---|---|---|
| B1017 | COLLISION DETECTION SIGNAL INPUT | - |
| B1107 | CAN COMMUNICATION (BIU) STUCK | - |
| B1401 | COMBINATION METER COLLATION | Model without keyless access with push button start system and without immobilizer control module |
| B1402 | IMMOBILIZER KEY COLLATION | |
| B1407 | COMBINATION METER COMMUNICATION | |
| B1408 | COMBINATION METER NON-VOLATILE MEMORY | |
| B1410 | TRANSPONDER COMMUNICATION | |
| B1411 | IMMOBILIZER ANTENNA | |
| U0073 | CONTROL MODULE COMMUNICATION BUS OFF | - |
| U0074 | CONTROL MODULE COMMUNICATION BUS "BODY-CAN" OFF | - |
| U0100 | LOST COMMUNICATION WITH ECM/PCM "A" | - |
| U0122 | LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULE | - |
| U0127 | LOST COMMUNICATION WITH TIRE PRESSURE MONITOR CONTROL MODULE AND/OR KEYLESS ENTRY CONTROL MODULE | Model without keyless access with push button start system |
| U0155 | LOST COMMUNICATION WITH INSTRUMENT PANEL CLUSTER (IPC) CONTROL MODULE | - |
| U0167 | LOST COMMUNICATION WITH IMMOBILIZER CONTROL MODULE | Model with keyless access with push button start system and with immobilizer control module |
| U0327 | SOFTWARE INCOMPATIBILITY WITH VEHICLE SECURITY CONTROL MODULE | Model with keyless access with push button start system |
| U0401 | INVALID DATA RECEIVED FROM ECM/PCM "A" | - |
| U0416 | INVALID DATA RECEIVED FROM VEHICLE DYNAMICS CONTROL MODULE | - |
| U0423 | INVALID DATA RECEIVED FROM INSTRUMENT PANEL CLUSTER CONTROL MODULE | - |
| U0426 | INVALID DATA RECEIVED FROM IMMOBILIZER CONTROL MODULE | Model with immobilizer control module |
| U0427 | INVALID DATA RECEIVED FROM VEHICLE SECURITY CONTROL MODULE | Model with keyless access with push button start system |
| U0430 | INVALID DATA RECEIVED FROM TIRE PRESSURE MONITOR CONTROL MODULE AND/OR KEYLESS ENTRY CONTROL MODULE | Model without keyless access with push button start system |
Diagnostic procedure:
- Using the Subaru Select Monitor, perform the clear memory of [Body Control]. Ref. to COMMON (diag)>CLEAR MEMORY .
- Using the Subaru Select Monitor, read the DTC of [Body Control] to check that there is no DTC displayed. Ref. to BODY CONTROL (DIAGNOSTICS)>Diagnostic Trouble Code (DTC) .
- Turn the ignition switch OFF → ON, and wait for 10 seconds or more.
- Using the Subaru Select Monitor, read the DTC of [Body Control] to check that there is no DTC displayed. Ref. to BODY CONTROL (DIAGNOSTICS)>Diagnostic Trouble Code (DTC) .NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs. Ref. to BODY CONTROL (DIAGNOSTICS)>Diagnostic Trouble Code (DTC)>LIST .