AWD ON/OFF Switching Mode: Procedure
CAUTION:
- Do not turn the power of the Subaru Select Monitor OFF during work, and do not disconnect the data link connector.
- On completing the work in FWD, switch back in AWD.
- Connect the Subaru Select Monitor.
- Turn the ignition switch to ON. (Engine OFF)
- Select [Diagnosis] on [Start] display of Subaru Select Monitor.
- On [Vehicle selection] screen, enter vehicle information and select [OK].
- On [Main Menu] screen, select [Each System].
- On [Select System] screen, select [Transmission].
- On [Select Function] screen, select [Work Support].
- On [Work Support] screen, select [AWD ON/OFF switching mode].
- Follow the messages displayed on the Subaru Select Monitor screen when working. Switching completes successfully if any of the following messages is displayed.
- When switching from AWD to FWD: [Switched to FF. To return to AWD, perform basic mode again.]
- When switching from FWD to AWD: [Switched to AWD. To return to FF, perform basic mode again.]
NOTE:- When switched to FWD, AWD light illuminates.
- If communication error occurs during switching mode, start in the [AWD ON/OFF switching mode] again.
- If operation is interrupted before the successful end message is displayed, perform the [AWD ON/OFF switching mode] from the beginning until confirming the operation is successfully ended.
If this mode fails to complete successfully, the cause is as follows.
- Select lever is not in "P range".
- Engine is running.