Control Valve Body: Installation
- Install new O-rings to the pressure pipe No. 1, pressure pipe No. 2 and pressure pipe No. 3.NOTE:
Apply CVTF to the O-rings.
- Install the pressure pipe No. 1, pressure pipe No. 2 and pressure pipe No. 3 to the transmission case.
- Install the control valve body.NOTE:
- Engage the manual valve to the manual plate.
- Lead the transmission harness through the point indicated by dashed line (a) in the figure in order to prevent it from being caught.
Tightening torque:
9 N.m (0.9 kgf-m, 6.6 ft-lb)
- Connect the connector.
- Install the oil pan and oil strainer. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>OIL PAN>INSTALLATION
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
- Refill CVTF to adjust the CVTF level. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>CVTF>INSPECTION
- Perform the [Clear AT learning value] and [AT learning mode] using Subaru Select Monitor. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>AT LEARNING