Standard Damper Model
CAUTION:
- Be careful not to damage the sensor.
- Do not apply excessive force to the sensor harness.
NOTE:
Check the identification (mark) on the sensor harness to make sure there is no twisting. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>GENERAL DESCRIPTION>SPECIFICATION .
- Install the sensor sub assembly rear.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Connect the sensor sub assembly rear connector.
- Install the rear wheels. Ref. to WHEEL AND TIRE SYSTEM>TIRE AND WHEEL>INSTALLATION .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .