Initial Setting: Notes
This procedure performs settings of the following data.
- Top dead position
- Bottom dead position
- Sliding resistance value
NOTE:
- Always perform the initialization with the vehicle parked. (Initialization cannot be operated during driving)
- Perform initialization for one seat at a time.
- Do not hit or apply impact or vibration to the glass, since the sliding resistance of door glass is being learned during the initialization.
- Do not perform the ignition operation during the initialization.
- The initialization is not required for the rear seats if the auto function is unavailable.
Perform the initialization according to the procedures by items below.
| Item | Procedure |
|---|---|
| When the regulator and motor assembly is replaced with a new part | A |
| When the motor power supply is lost due to removing and installing of the battery terminals and the regulator & motor assembly connector during the power window operation | A |
| When the power window system was initialized by the Subaru Select Monitor | A |
| When a power window related part such as glass and running channel was replaced | B |
| When the phenomenon that the door glass does not close fully (incorrect reverse operation) occurred | B |
| When the phenomenon that the door glass does not open fully (incorrect stop operation) occurred | B |