LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2024 >> Crosstrek Base >> Repair and Diagnosis >> Engine Mechanical >> Engine Lubrication System >> Oil Level Switch >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Oil Level Switch: Removal

CAUTION: If the engine oil is spilt over the engine, exhaust pipe or the under cover, completely wipe it off to avoid emission of smoke or causing a fire.
NOTE: Components: Ref. to LUBRICATION (H4DO)>GENERAL DESCRIPTION>COMPONENT>OIL PAN .
  1. Remove the striker assembly front hood. Ref. to EXTERIOR BODY PANELS>FRONT HOOD>DISASSEMBLY .
    NOTE: This procedure is necessary to prevent the lifting device and the striker assembly front hood from contacting with each other and causing damage. However, the procedure may be omitted if it is assured that the lifting device to be used will not make a contact.
  2. Fully open the hood COMPL front. Ref. to REPAIR CONTENTS>NOTE>STAY ASSEMBLY FRONT HOOD .
  3. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  4. Remove the V-belt covers.
    G16760387Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the air intake duct. Ref. to INTAKE (INDUCTION) (H4DO)>AIR INTAKE DUCT>REMOVAL .
  6. Remove the air intake boot.
    1. Remove the clip.
    2. Loosen the clamp.
      G16760376Courtesy of SUBARU OF AMERICA, INC.
    3. Remove the air intake boot, and place it aside so that it does not interfere with the work.
      CAUTION: Be careful not to pull out the PCV hose.
    G16760377Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the TCM. (Impreza model) Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>TRANSMISSION CONTROL MODULE (TCM)>REMOVAL .
  8. Remove the pitching stopper. (Crosstrek model) Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>TRANSMISSION MOUNTING SYSTEM>REMOVAL>PITCHING STOPPER .
  9. Drain the engine oil. Ref. to LUBRICATION (H4DO)>ENGINE OIL>REPLACEMENT .
  10. Remove the front exhaust pipe. Ref. to EXHAUST (H4DO)>FRONT EXHAUST PIPE>REMOVAL .
  11. Remove the nuts which secure the engine mounting to the crossmember COMPL front.
    G16761032Courtesy of SUBARU OF AMERICA, INC.
  12. Remove the electric power steering gearbox. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>ELECTRIC POWER STEERING GEARBOX>REMOVAL .
  13. Remove the front drive shaft LH. Ref. to PROPELLER SHAFT/DRIVE SHAFT/AXLE>FRONT DRIVE SHAFT>REMOVAL .
  14. Using the ST1, install the ST2 to the engine unit.

    Preparation tool  :

    ST1: BOLT (18363AA050)

    ST2: HANGER (18360AA040)

    Tightening torque: 

    43 N.m (4.4 kgf-m, 31.7 ft-lb)

    G16761199Courtesy of SUBARU OF AMERICA, INC.
  15. Lift up the engine with a lifting device and wire ropes.
    CAUTION: When lifting up the engine, pay attention to the clearance of each part and be careful not to lift the engine too much, in order to prevent damaging the vehicle.
    G16523762Courtesy of SUBARU OF AMERICA, INC.
    (A) To engine rear hanger
    (B) To ST (HANGER)
  16. Remove the engine mounting LH.
    G16761774Courtesy of SUBARU OF AMERICA, INC.
  17. Disconnect the connector (A) from oil level switch.
  18. Remove the clip to remove the oil level switch.
    G16761775Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals