Steering Wheel: Installation
CAUTION:
- Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM" . Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
- If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position .
- Align the center position of the steering roll connector. Ref. to AIRBAG SYSTEM>ROLL CONNECTOR>ADJUSTMENT .
- Install the steering wheel assembly, and connect the connector.
Tightening torque:
39 N.m (4.0 kgf-m, 28.8 ft-lb)
Clearance:
Between column cover assembly and steering wheel: 4 - 6 mm (0.16 - 0.24 in)
- Install the driver's airbag module. Ref. to AIRBAG SYSTEM>DRIVER'S AIRBAG MODULE>INSTALLATION .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
- Perform "VDC sensor midpoint setting mode". Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM & H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE .