MULTIVIEW Control Module
WARNING: This page is about a different car, the 2023 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
- Install the multiview control assembly.
- Install the cockpit control module. Ref. to ENTERTAINMENT & MONITORING>COCKPIT DISPLAY>ASSEMBLY .
- Install the grille ventilation assembly center. Ref. to AIR CONDITIONER>AIR VENT GRILLE>INSTALLATION>CENTER GRILLE ASSEMBLY .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
- When the multiview control assembly has been replaced with a new part, perform the data transfer.
- Using the Subaru Select Monitor, select [Carrying over Calibration data when replacing the Camera ECU] in [Work Support] of [Front & Side Camera/Multi View Monitor]. Ref. to COMMON (DIAGNOSTICS)>WORK SUPPORT>OPERATION .
- Perform the operation according to the display screen.