MULTIVIEW Control Module

WARNING: This page is about a different car, the 2023 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Remove the grille ventilation assembly center. Ref. to AIR CONDITIONER>AIR VENT GRILLE>REMOVAL>CENTER GRILLE ASSEMBLY .
Remove the center information display assembly. Ref. to ENTERTAINMENT & MONITORING>COCKPIT DISPLAY>REMOVAL .
Remove the multiview control assembly.
1. Disconnect the cable CCM connector.
2. Remove the screws to remove the multiview control assembly.
  NOTE: Remove the screws on LH side in the same procedure as on the RH side.

Courtesy of SUBARU OF AMERICA, INC.