Scan Tool Output Controls - Tire Pressure Monitoring
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
SCAN TOOL OUTPUT CONTROLS - TIRE PRESSURE MONITORING
| Scan Tool Output Control | Additional Menu Selections | Description |
|---|---|---|
| TPM Option Enable | Module Setup/New RCDLR | After replacing the Remote Control Door Lock Receiver (RCDLR) assembly, the SPS reprogramming must be used to enable the TPM option, refer to REMOTE CONTROL DOOR LOCK RECEIVER PROGRAMMING AND SETUP . |
| Tire Type/Pressure Selection | Module Setup | After replacing the RCDLR assembly, the scan tool must be used to select the correct tire type and the front and rear tire pressures for the vehicle being serviced. Refer to REMOTE CONTROL DOOR LOCK RECEIVER PROGRAMMING AND SETUP . |
| TPM Learn Mode | Module Setup | The sensor learn procedure must be performed after every tire rotation, RCDLR replacement, or sensor replacement. Once the TPM learn mode has been enabled, each of the sensors unique identification (ID) codes can be learned in to the RCDLR's memory. Refer to TIRE PRESSURE SENSOR LEARN . |