LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1987 >> Samurai Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Engine Electrical Devices) >> Repair Instruction >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Installing APP Assembly
G04841321Courtesy of SUZUKI OF AMERICA CORP.
  1. Install the upper attachment bolt into the APP assembly.
  2. Install the APP assembly into the vehicle.
    CAUTION: Refer to FASTENER NOTICE .
  3. Install the remaining attachment bolts into the APP assembly.

    Tightening torque 

    Tighten the bolts to 25 N.m (18 lb ft)  .

    Fig 2: Identifying APP Sensor Harness Connector
    G04841322Courtesy of SUZUKI OF AMERICA CORP.
  4. Connect the APP sensor harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.
  5. Install the CPA to the APP sensor harness connector.
  6. Install the driver knee bolster. Refer to KNEE BOLSTER REPLACEMENT .
  7. Install the instrument panel left lower closeout panel. Refer to INSTRUMENT PANEL INSULATOR PANEL REPLACEMENT - LEFT SIDE .
scientia non olet · About LEMON Manuals