Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Transaxle Case Fluid Passage Seals (2 Of 2)

Courtesy of SUZUKI OF AMERICA CORP.

Install 2 new transaxle case fluid passage seals (86) into the transaxle case fluid ports.

Fig 2: Identifying Control Valve Body Assembly, Manual Valve Link & Manual Shift Detent Lever Assembly
Courtesy of SUZUKI OF AMERICA CORP.
While holding the control valve body assembly (39), connect the manual valve link (336) to the manual shift detent lever assembly (710).

Fig 3: Identifying Transaxle Case Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Install the 6 control valve body assembly to transaxle case bolts and hand tighten.

Fig 4: Identifying Tightening Sequence Of Control Valve Body Assembly-To-Transaxle Case Bolts
Courtesy of SUZUKI OF AMERICA CORP.

CAUTION: Refer to FASTENER NOTICE .
Tighten the control valve body assembly-to-transaxle case bolts in sequence.
Tightening torque

Tighten the bolts to 10 N.m (89 lb in) .

Fig 5: Identifying Control Valve Body Fluid Passage Cover & Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Install a new control valve body fluid passage cover gasket (38).
Install the control valve body fluid passage cover (37).
Install the 2 control valve body bolts (31).
Tightening torque

Tighten the bolt to 10 N.m (89 lb in) .
Install the transmission wiring harness. Refer to INSTALLATION PROCEDURE .
After the transmission is reassembled and filled with fluid perform the transmission adaptive learn procedure. Refer to TRANSMISSION ADAPTIVE LEARN AND TRANSMISSION NEUTRAL LEARN .