LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1992 >> Sidekick JS, 2D Utility >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Fuel System >> Injector (TBI) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Injector (TBI): Installation

  1. Apply thin coat of fuel to new injector "O" rings. Install "O" rings on injector. Insert injector into throttle body. Carefully install wiring harness connector to injector.
  2. Apply thread locking compound to injector cover mounting screws and install injector cover. Tighten injector cover screws to 17 INCH lbs. (1.9 N.m). Connect fuel feed pipe with new "O" ring. Tighten fuel feed pipe bolts to 72-102 INCH lbs. (8.0-11.9 N.m). Connect negative battery cable. Check for fuel leaks.
  3. With control relay connected, install a jumper wire between control relay Pink/Black and Black/White wires. Control relay is located on left kick panel. See Figure . Turn ignition on (engine off) to activate fuel pump.
scientia non olet · About LEMON Manuals