RWAL Power Relay
NOTE:
Terminal numbers for RWAL power relay are a mirror image of connector terminals. See Figure.
- Disconnect negative battery cable. Remove radio speaker (if equipped) from lower left side of dash. Unbolt engine ECM with cover, bracket and fuse box from steering column holder.
- Disconnect Yellow connector from RWAL power relay. Remove relay. Check continuity between RWAL power relay terminals No. 2 and 4. Continuity should not exist. With battery voltage applied between terminals No. 1 and 3, continuity should exist between terminals No. 2 and 4. If continuity is not as specified, replace RWAL power relay.