Fuel Pressure Test (Esteem)
- Release fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE . Remove fuel inlet hose banjo bolt. Install fuel pressure adapter and gauge in banjo bolt hole. See Fig 1 .
- Verify battery voltage is 11 volts or greater. Turn ignition on to operate fuel pump for 3 seconds. Turn ignition off. Repeat 3-4 times, and check fuel pressure. See FUEL PUMP PERFORMANCE and REGULATED FUEL PRESSURE tables. Start engine. Measure fuel pressure at idle. Turn ignition off.
- If pressures are not within specification, check for defective fuel pump, pressure regulator or restriction in fuel system. See CIRCUIT TESTS . Repair as necessary. Remove fuel pressure gauge and reinstall fuel inlet hose. Start engine to ensure no fuel leakage exists.
FUEL PUMP PERFORMANCE
| Application | (1) psi (kg/cm2 ) | ||||
|---|---|---|---|---|---|
| Esteem | (2) 38.4-44.0 (2.7-3.1) | ||||
|
|||||
REGULATED FUEL PRESSURE
| Application | (1) psi (kg/cm2 ) | ||||
|---|---|---|---|---|---|
| Esteem | (2) 28.4-34.1 (2.0-2.4) | ||||
|
|||||