Cruise Control Main Switch
- Disconnect electrical connector at cruise control main switch. Note electrical connector terminal identification. SeeFig 1
. Connect jumper wire between positive battery terminal and terminal No. 3. Connect jumper wire between negative battery terminal and terminal No. 5.
- Ensure cruise control main switch is in OFF position. Connect voltmeter positive lead to terminal No. 1 and negative lead to terminal No. 5. Turn cruise control main switch to ON position.
- Voltmeter should indicate 10-14 volts. Turn cruise control main switch to OFF position. Voltmeter should indicate no voltage. Remove test equipment. Replace cruise control main switch if defective.
Courtesy of SUZUKI OF AMERICA CORP.