Electronic Control Unit (Ecu) Reprogramming Verification Procedure Using The SUZUKI SDS Tool (TS 05 10056)

ELECTRONIC CONTROL UNIT (ECU) REPROGRAMMING VERIFICATION PROCEDURE USING THE SUZUKI SDS TOOL

TECHNICAL SERVICE BULLETIN

CONDITION

To verify that the latest Pass-Thru calibration information is programmed into the on-board ECU if glove box reprogram label is not complete and affixed to the glove box door.

CAUSE

N/A

CORRECTION

Follow the verification process outlined below.

Always properly complete the reprogramming label and affix it to the glove box door after verifying or performing pass-thru reprogramming.

Please refer to the "Module reprogramming using SDS" training course on suzukizone.com for more information.

PART(S) INFORMATION

Part Numbers	Description	QTY	Notes
09910-06521	SDS Tool Kit	1	Kit includes USB Cable, Diagnostic Interface Box and DLC Cable
99963-01501-224	Reprogram Label	1	Please fill out completely and affix to the interior of the glove box

PC Software and Database Verification Process

1. To verify the current Pass-Thru Reprogramming software and database are installed in your PC. Open the Suzuki Pass-Thru Reprogramming Tool as if to reprogram a vehicle. Then left click the "P" icon on the top left corner of the screen.
   Fig 1: Locating "P" Icon

   Courtesy of SUZUKI OF AMERICA CORP.
2. Select "About Pass-Thru Reprogramming..."
   Fig 2: Locating "About Pass-Thru Reprogramming"

   Courtesy of SUZUKI OF AMERICA CORP.
3. Version information is displayed. If you do not have the latest version, you must download the Pass-Thru Reprogramming Software and install it then download the Database and install it.
   Fig 3: Message Appears - [4028] ECU Already Has Latest Version

   Courtesy of SUZUKI OF AMERICA CORP.

ECU Calibration Verification

1. Connect the SDS to the vehicle and attempt reprogram.
2. If the "This ECU is suitable for reprogramming" screen appears, continue the reprogram and the vehicle will have the latest update. Write the information from "The reprogramming is successful" screen onto the reprogram label (see step 7) and affix it inside the glove box as indicated in the corresponding TSB.
3. If an error screen appears "4028 ECU already has latest version" appears, the ECU already has the most current calibration. If there is no glove box label indicating the current calibration, write in the Pass-Thru version and Database version on the Reprogram Label P/N 99963-01501-224
   Fig 4: "4028 ECU Error Screen

   Courtesy of SUZUKI OF AMERICA CORP.
4. Fill out the Reprogram Label P/N 99963-01501-224 (the part number and version will be displayed at the "The reprogramming is successful" screen). Then affix the label to the back of the glove box door as pictured below.
   Fig 5: Filling Out Reprogram Label

   Courtesy of SUZUKI OF AMERICA CORP.