LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2000 >> Swift GL, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal, Overhaul And Installation >> Fuel System >> Fuel System Pressure Release
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel System Pressure Release

CAUTION: DO NOT perform this procedure when engine is hot. Doing so may have an adverse effect on catalytic converter.
  1. Place transmission in Neutral (M/T) or Park (A/T). Set parking brake and block drive wheels. Disconnect fuel pump relay. See FUEL PUMP RELAY LOCATION  table.
  2. Remove fuel filler cap to release fuel vapor pressure in fuel tank. Reinstall fuel filler cap. Start engine and run until engine dies. After engine dies, crank engine 2-3 times for about 3 seconds to dissipate fuel pressure in lines. To restore normal operation, reinstall fuel pump relay.
    FUEL PUMP RELAY LOCATION

    Application (1) Location
    Esteem & Swift Engine Compartment Relay Block
    Grand Vitara & Vitara In Instrument Panel Fuse Block, Under Lower Left Of Instrument Panel
    (1) See Fig 1 -Fig 4
    .
Fig 1: Locating Main Relay & Fuel Pump Relay (Esteem)
G95G34625Courtesy of SUZUKI OF AMERICA CORP.
Fig 2: Locating & Identifying Relays (Swift)
G95I34627Courtesy of SUZUKI OF AMERICA CORP.
Fig 3: Locating Main Relay & Fuel Pump Relay (Vitara)
G99B51061Courtesy of SUZUKI OF AMERICA CORP.
Fig 4: Locating Main Relay & Fuel Pump Relay (Grand Vitara)
G99C50775Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals