Specifications Index
VERONA SPECIFICATIONS INDEX
| System | Specification/Procedure | |||
|---|---|---|---|---|
| Air Conditioning | ||||
| Service | General Description | |||
| Torque | Tightening Torque Specifications | |||
| Axle Nut/Hub Nut | ||||
| Front | 236 Ft. Lbs. (320 N.m) | |||
| Battery | Battery Service Specifications | |||
| Brakes | ||||
| Bleeding Sequence | BRAKE BLEEDING SEQUENCE | |||
| ABS Anti-Lock Brake System | ||||
| Torque | Tightening Torque Specifications | |||
| Service Specifications | General Specifications | |||
| Disc Brakes | ||||
| Service Specifications | DISC BRAKE SPECIFICATIONS | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Charging | ||||
| Generator | GENERATOR DESCRIPTION | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Drive Belts | ||||
| Adjustment | SERPENTINE ACCESSORY DRIVE BELT | |||
| Belt Routing | n/a | |||
| Engine Cooling | ||||
| General Service Specifications | General Description | |||
| Radiator Cap Pressure | 13.1-17.4 psi | |||
| Thermostat R & I | Thermostat Removal & Thermostat Installation | |||
| Water Pump R & I | Water Pump Removal & Water Pump Installation | |||
| Engine Mechanical | ||||
| Compression | Compression Test | |||
| Oil Pressure | 85 - 145 kPa (12.3 - 21 psi) | |||
| Overhaul | Refer to appropriate Component specification information under Repair Instructions . | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |||
| Flywheel/Flex Plate/Drive PlateTorque | 52-59 Ft. Lbs. (70-80 N.m) | |||
| Fuel System | ||||
| Pressure Specification | ||||
| Key On, Engine Off | 45.0 psi (3.2 kg/cm2 ) | |||
| Engine Idling | 41.0-47.0 psi (2.9-3.3 kg/cm2 ) | |||
| Fuel Pressure Test Procedure | Pressure test procedure not available, refer to Test . | |||
| Fuel Filter Location | Fuel Filter Removal | |||
| Fuel Filter R & I | Fuel Filter Removal & Fuel Filter Installation | |||
| Ignition | ||||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | |||
| Ignition Wires | Specifications | |||
| Spark Plug | ||||
| NGK (BKUR6ETB) | ||||
| Gap | .031 In. (0.8 mm) | |||
| Torque | 15-22 ft. lbs.(20-30 N.m) | |||
| Starting | ||||
| Starter | STARTER SPECIFICATIONS | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Wheel Alignment | ||||
| Adjustment Specifications | VERONA | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Wheel & Tire | ||||
| Wheel Lug Nut Torque | 81 Ft. Lbs. (110 N.m) | |||