Programming Transmitter Code
NOTE:
- Three transmitter codes can be programmed at the same time.
- When fourth transmitter code is programmed, the oldest one will be cleared automatically.
If transmitter / door lock controller is replaced with a new one or additional transmitter(s) is necessary, program transmitter code (s).
- Confirm that all doors are closed and ignition key is out of ignition key cylinder
- Open driver side door.
- Turn ignition switch to ON position, and then drawn ignition key from ignition key cylinder within 10 seconds after that.
- Push and release driver side door switch (1) at 3 times by hand within 20 seconds after removing ignition key from ignition key cylinder.
- Turn ignition switch to ON position, and then drawn ignition key from ignition key cylinder within 10 seconds after that.
- Confirm that all doors are operated from lock to unlock.
With this, registration mode.
- Push "UNLOCK" button (2) on transmitter (3) and confirm that all doors are operated from lock to unlock.
With this, code registration is completed.
- If you want to program the additional transmitter, repeat the procedure from Step 1 through Step 7.
- Make sure that keyless entry system properly operates by operating programmed transmitter(s).