LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> Swift + >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls & Fuel - 1.6L - Introduction (2 Of 2) >> Repair InstructionsEngine Control Module Replacement >> Fuel Tank Pressure Sensor ReplacementRemoval Procedure >> Removal ProcedureInstallation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal ProcedureInstallation Procedure

  1. Remove the fuel fill cap.
    2. CAUTION: Refer to Battery Disconnect Caution .
  2. Disconnect the negative battery cable.
  3. Remove the rear seat. Refer to Rear Seat Cushion Replacement .
    4. Fig 1: Removing And Installing Fuel Pump Access Cover
    GM1376163Courtesy of GENERAL MOTORS CORP.
  4. Remove the fuel sender assembly access cover.
    5. Fig 2: View of Fuel Tank Pressure Sensor Electrical Connector
    GM1376164Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the fuel tank pressure (FTP) sensor electrical connector.
  6. Remove the FTP from the fuel sender assembly.
scientia non olet · About LEMON Manuals