DTC Chart

DTC CHART

DTC	SDT	Diagnostic item is detected when...	Reference
[P1801]	INITIAL START	Due to removal of battery which cuts off power supply to transfer control unit, self-diagnosis memory function is suspended.
[P1802]	CONTROL UNIT (1,2,3)	Malfunction is detected in the memory (RAM) system of transfer control unit.
[P1803]		Malfunction is detected in the memory (ROM) system of transfer control unit.
[P1804]		Malfunction is detected in the memory (EEPROM) system of transfer control unit.
[P1807]	VHCL SPEED SEN.AT	Malfunction is detected in output shaft revolution signal that is output from TCM through CAN communication. Improper signal is input while driving.
[P1808]	VHCL SPEED SEN.ABS	Malfunction is detected in vehicle speed signal that is output from ABS actuator and electric unit (control unit) through CAN communication. Improper signal is input while driving.
[P1809]	CONTROL UNIT 4	AD converter system of transfer control unit is malfunctioning.
[P1810]	4L POSI SW TF	Improper signal from 4LO switch is input due to open or short circuit.
[P1811]	BATTERY VOLTAGE	Power supply voltage for transfer control unit is abnormally low while driving.
[P1813]	4WD MODE SW	More than two switch inputs are simultaneously detected due to short circuit of 4WD shift switch.
[P1814]	4WD DETECT SWITCH	Improper signal from wait detection switch is input due to open or short circuit.
[P1816]	PNP SW/CIRC	When PNP switch signal is malfunctioning.	(A/T models), (M/T models)
[P1817]	SHIFT ACTUATOR	Motor does not operate properly due to open or short circuit in actuator motor. Malfunction is detected in the actuator motor. (When 4WD shift switch is operated and actuator motor is not operated) Malfunction is detected in transfer shift high relay or transfer shift low relay.
[P1818]	SHIFT ACT POSI SW	Improper signal from actuator position switch is input due to open or short circuit. Malfunction is detected in actuator position switch.
[P1819]	SHIFT ACT CIR	Malfunction is detected in transfer shut off relay 1 and transfer shut off relay 2. Malfunction occurs in transfer control device drive circuit.
[P1820]	ENGINE SPEED SIG	Malfunction is detected in engine speed signal that is output from ECM through CAN communication. Improper signal is input while driving.

NOTE: If "SHIFT ACT POSI SW [P1818]" or "SHIFT ACT CIR [P1819]" is displayed, first erase DTC. ("SHIFT ACT POSI SW [P1818]" or "SHIFT ACT CIR [P1819]" may be displayed after installing transfer control unit or transfer assembly.)